The entrance cleaning machine uses an aqueous solution of aluminum or cerium oxide as a polishing agent, which is added to the disc brush during the rolling rubbing process through the water spray pipe between the upper rollers. Since a solid aqueous solution polishing agent is used, when the concentration is too high, it can easily cause the nozzle to become clogged. When it is observed that the polishing agent nozzle is clogged during use, it should be cleared in time and the concentration of the diluted polishing agent should be adjusted. Follow these steps to clean polish and water spray hoses.
1. Remove the cleaning machine baffle, raise the upper roller of the cleaning machine, and turn off the power supply and water supply valve.
2. Loosen the fixing bolts at both ends of the nozzle and remove the nozzle.
3. Use a high-pressure water gun to drive pure water from the inlet of the nozzle into the nozzle to form water pressure. Observe the water output from each nozzle and use a paper clip to clear it.
4.Clean the nozzle, install it back to its original position, tighten the bolts, and pay attention to the direction of the nozzle remaining unchanged before disassembly and cleaning.
Cleaning and adjusting the air knife drying area
The last water tank of the cleaning machine is filled with heated (temperature around 45°C) high-purity water. Therefore, the water stains attached to the surface of the original glass can be blown away and evaporated by the high-strength wind of the air knife after entering the drying area. The blade of the air knife forms a certain acute angle with the plane where the original glass piece is located. Every time you disassemble or install the air knife or change its position, be sure to measure the angle and keep it unchanged.
1. Clean the glass debris, labels, paper jams and other dirt in the drying area, and wipe the air knife, roller table and other parts with a clean cotton cloth to ensure cleanliness.
2. Remove the primary filter plate and secondary filter bag for the fan, use compressed air to blow out the dust inside, check for damage or blockage, and replace them regularly.
3.Use a saw blade to probe into the air knife edge and check whether there are filter bag fibers and other debris blocking the knife edge. Through production practice in the past few years, we have realized that as long as the entrance cleaning machine is maintained and maintained regularly and carefully according to the above procedures, when the process is normal, the cleaning effect of the original glass can be guaranteed to a large extent and the coating can be guaranteed. The quality of glass products is stable.
We have been in glass field for more than 20 years, our newly designed high-end cleaning machine has good stability and can be used alone or connected to other equipment.
Post time: Nov-21-2023
